Lost half a day to a chafed wire bundle hiding behind a loom clamp on a King Air
Had a nav radio acting up last Tuesday on a King Air 200, signal would cut out every time we ran the flaps. Bench checked the unit twice, swapped it with a known good one, same thing. Spent most of the morning chasing grounds before I finally grabbed a mirror and a light and got behind the bundle near the wing root. Turned out a wire had rubbed through its jacket against a loom clamp, and the flap motor harness moving was pulling it just enough to short. Nobody had touched that area in a while so it never showed up on a normal wiggle check. I put a piece of chafe tape and a new clamp on it, reran the flaps twenty times, and the radio held steady. Cost me about five hours and two cups of cold coffee for a ten minute fix once I found it. What's your go-to move for finding a fault that only shows up when something else moves?