Saw a 60-year-old riveted boiler at the Henry Ford Museum and spent 30 minutes just staring at the seams
I was at the Henry Ford Museum in Dearborn, Michigan over the weekend with my family and we walked past this old steam boiler from like 1920. I stopped dead because the rivet pattern on the shell was so tight and even, maybe 2 inch spacing the whole way around, and I could not stop thinking about how many heats those guys had to drive and how many hammers it took to set every single one. There was a small placard showing a cross section of the lap joint and it hit me that I have never once had to think about a seam like that on any job I have been on. My wife was ready to move on to the cars and I was still squatting there trying to see if the knuckle radius looked consistent. It made me wonder how many of those old timers could walk up to a shell and tell you the rivet pitch just by eyeballing it. I snapped a few pictures of the door hinge and the hand hole plate too. Does anyone here work on any heritage or museum boilers, and if so do you get access to see the inside of the shell or is it all sealed up?