DAE remember the old timer in Tulsa who showed me a hand-cut dovetail with a $12 saw, because I used to think you needed a jig | Cabinetmakers - Chatter Central
DAE remember the old timer in Tulsa who showed me a hand-cut dovetail with a $12 saw, because I used to think you needed a jig
I was in a guy's garage shop over in Tulsa about 3 months ago buying a used router, and I spotted this little drawer on his bench with dovetails so tight you couldn't slip a receipt in the joints. When I asked what jig he ran, he just laughed and said "a jig's for speed, not for learning" and walked me through cutting one by hand with a $12 pull saw he keeps sharpened himself. Been cutting them by hand on small boxes ever since, so what did it take for you to give up a jig and go old school?
What makes you so sure a jig is only for speed? I've run a router jig for years and my joints still come out tight and clean, so the "learning" argument never really held water for me. A jig is just a tool, and a good woodworker can still learn the grain and the fit while using one.