Found out a 3 foot level can be off by a quarter inch and nobody checks them
So I was reading a post from a tool repair guy in Ohio and he said most levels guys bring in have never been checked once. He puts them on a flat bench, flips them end for end, and a ton of them read different both ways. One of his examples was a 3 foot level that was a quarter inch out over its length. That doesn't sound huge but it stacks up fast when you're setting door frames or laying out a slab. Now I flip every level on the truck before I trust it, takes like 20 seconds. Has anyone else had a level go bad on them or am I just late to this?